- Before starting the Stenter, check whether the mechanical, electrical, instrumentation and safety protection devices are in good condition. Set the temperature according to the process requirements, and then turn on the circulating fan. During the heating stage, the speed of the main engine is 15m/min, and the cloth can be loaded after reaching the set temperature. After meeting the requirements of cloth loading, turn on the active brush wheel, press the cloth on the needle plate, try to make both sides as close as possible, and at the same time put down the passive brush wheel, and tighten the fabric. When starting the host, you should ring the bell to notify the operator at the rear of the car. When the cloth reaches the rear of the car, the cloth should be worn at the fastest speed and the fabric should be tightened.
- The safety guards at the cloth entrance and exit of the machine should be intact to prevent the needle cloth clips from hanging on the sleeves, and at the same time to prevent the chain from breaking and flying out and hurting people.
3. The emergency stop switch of the rolling car rope and the safety of the cloth feeding are reliable and useful. When the cloth is worn, the machine must be stopped, and the upper roller must be lifted by pressing. Don't be negligent.
4. The grey cloth must be sewn, and knots are not allowed to avoid damage to the rubber roller and cause accidents.
5. Before shutting down, the temperature should be reported to the heat-loading heat-conducting oil furnace room. Then stop the circulation fan, open the door to cool down, and run the main engine and the top exhaust fan separately, and stop the machine when the temperature drops to 80℃, so as to avoid uneven heating of the chain card clothing.
6. Check the heat transfer oil pipeline in the oven regularly. If there is oil leakage, it should be dealt with in time; before and after the shift, the fly in the machine should be cleaned, and the fly and oil in the exhaust pipe should be cleaned regularly to eliminate fire hazards.
7. A steam pipe is added to the exhaust duct on the top of the oven, which can be used to cool down and extinguish the fire. When the internal temperature is 165℃, the steam valve will be in a normally open state; a wire mesh guard is installed on the heat sink to prevent flying flowers or fabric from falling on the heat sink Cause burning.
- The car must be shut down when cleaning or refueling. Wiping the chain, brushing the needle plate, or rubbing the roller is strictly prohibited when driving to prevent finger injury. When cleaning or repairing the car on or in the Flat Screen Printer, a stop sign must be hung up on the console to prevent accidents caused by others driving.
