The rubber gloves are first sliced through a rubber mixer, which is fed into a sol tank and mixed with gasoline. After the sol is emulsified and prepared, it is pumped to the latex intermediate tank. The rubber solution dissolved in gasoline is fed from the top of the distillation column, after steam heating and distillation, the light gasoline is heated into the gas phase, the gasoline gas is mixed and cooled by cold water. The oil-water mixture then reaches the oil-water separator, where the oil and water are layered. The upper layer recovers gasoline, and the lower part is pumped to the cooling water tower for cooling. After cooling, the gasoline in the distillation column is cooled again. The latex in the distillation tower still is sent to the latex mixing tank and mixed according to its own pressure, and adjusted to a centrifuge to separate the latex material of the gloves, which is used after toning and filtration.
The Powder Free Nitrile Gloves model is first cleaned with acid and alkali, then with water. The cleaned model is first immersed in hot water and heated, then immersed in a coagulant and dried and then dipped. After dipping, it is sent to the oven to start drying, the fiber inner sleeve is added, hot water is poured, and then sent to the oven for vulcanization, drying and molding. After the gloves are demolded, inflate and check, set at low temperature, dry at medium temperature, wash, dehydrate, inflate the gloves after drying, and then package and send them to the product warehouse.
Powder Free Nitrile Gloves https://www.disposablesgloves.com/Powder-Free-Nitrile-Glof
