How To Maintain Stenter


Under normal circumstances, every time the Stenter setting machine runs for a period of time, it needs to be lubricated and maintained.

   Under normal circumstances, every time the Stenter setting machine runs for a period of time, it needs to be lubricated and maintained. At the same time, due to the different lengths of running time, the specific measures taken are also different. Generally speaking, when the stenter setting machine has been running for sixty hours, the staff needs to open the covers on both sides of the heating chamber to clean and lubricate the mechanical transmission parts.

  If there is any damage, aging or looseness during the inspection, it should be dealt with in time. In addition, because the stenter setting machine equipment is an electric heating device, high static electricity may be generated due to factors such as environment and air when processing chemical fiber fabrics. To ensure safety, a reliable grounding wire should be installed on the body.

  At the same time, it should be noted that the diameter of the ground wire must reach 3 square millimeters. In addition, during the operation of the stenter setting machine, no repairs or inspections are allowed to prevent burns. In addition, it should be noted that it is strictly forbidden for operators to wear long hair, wear skirts, and gloves to work. They must operate according to high temperature work requirements.

  It mainly refers to cleaning the main chain and gears of the stenter setting machine equipment, and then lubricating the running parts such as the gear shaft. When the working time of the equipment is over one hundred hours, the staff need to open the covers on both sides of the heating compartment for inspection operations, mainly to check the specific conditions of the wires, circuits, heating pipes and connections.

   Finally, I would like to remind everyone that you need to pay attention to the temperature of the Flat Screen Printing Machine during daily work. If the temperature exceeds 240°C, it may cause an open flame. Therefore, do not place flammable and explosive materials around the Flat Screen Printing Machine, and prepare relevant fire extinguishing tools to avoid accidents.