Maintenance Items For Open Type Rotary Screen Printer


If the chain of the Hot Air Stenter is too loose, you can first take measures to remove the part for adjustment. If it is severely stretched, it should be replaced.

  In the printing industry of our country, the Open Type Rotary Screen Printer is a large-scale work equipment with high cost, long use time, and late maintenance. It also needs more attention. Because no matter how expensive the machine is, no maintenance will reduce the service life and reduce the efficiency. So today, the small series and we will talk about how to do the daily maintenance and maintenance of Open Type Rotary Screen Printer?

   Printer ink maintenance and repair the following elements:

  The rolling development bearings of all enterprises can be manually removed and washed, and new grease can be added, and calcium-sodium-based grease can be used.

   All rubbing surfaces to remove dirt? ? Dirt, especially the chain and sprockets are to be cleaned and refilled with oil.

   The inspection includes whether the stove is leaking smoke. If smoke is found, the drum smoke ring, stove and chimney should be analyzed and inspected. If the problem is found to be damaged, it should be repaired and replaced in time. The model of electric heating equipment should be checked for damage to the electric heating tube, and the damaged should be adjusted and replaced.

   Replace the lubricant in the high-speed Open Type Rotary Screen Printer worm gear reducer. The lubricating oil can be 10-20 or 30 oil.

   After all parts are repaired, the whole machine is assembled, the machine is started, and the machine is running normally. Properly heat the roller, and put a small amount of carton packaging mechanical oil to make it cladding on the inner surface of the roller, and then cut off all power. If necessary, the exterior of the machine can be repainted, dried and covered with plastic paper, and stored in a dry place.

   If the chain of the Hot Air Stenter is too loose, you can first take measures to remove the part for adjustment. If it is severely stretched, it should be replaced.